![]() ![]() I used my chisel to remove a good amount of wood where I found the red lipstickĪfter adjusting the opening, the lock was able to close fully. When I opened the door I could see wherever the red lipstick has transferred and I knew I needed to chisel that section down in order for the lock to be able to close. Then I closed the door and attempted to lock it a few times. I extended the lock out and put the lipstick on the lock wherever I thought it was hitting. I used a trick to fix this, and all I needed was a tube of lipstick and my chisel. When I tested it, the lock didn’t actually go into the hole. ![]() Unfortunately when I put the lock in it did not fit like it should. The reinforcement plate for the deadbolt didn’t fit the current opening either so I widened it the same way as before with my drill and chisel. I secured it with the mounting screws and tested the deadbolt fit in my current setup. To expand the recess a little I traced the outline of the plate and chiseled away material until it fit. Right off the bat I had a small fitment issue as the mounting plate was a bit too big. First I started off by removing the old lock and trying to install the Schlage deadbolt in it’s place. The install is pretty similar to most other deadbolts and only requires a screwdriver, a drill and maybe a chisel if you have some fit issues. Remove The Old Lock And Fit New Keyless Door Deadbolt Attach Reinforcement Plate and Strike Plateġ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |